This Drive Shaft fits Many DODGE, CHRYSLER AND PLYMOUTH VEHICLES THAT USE 7290 (316) 2.622 x 1.126 OR 7260 (315G) 2.125 X 1.078 Style U-Joints With inside clips. Our Custom Made DriveShaft are made using HD 3X. 083 DOM tubing to your Specifications with a maximum length of 60 from center of u-joint to center of u-joint. Made greasable u-joints and is fully balanced.
Important Info , if ordering shaft without trans yoke we will need the length of your slip yoke from the center of the u-joint hole to the end of the barrell. 7290 u-joint 2.622" X 1.126" width is the dia between flat clip surface. 7260 u-joint 2.125" X 1.078". DRIVESHAFT IS MADE TO YOUR SPECIFICATIONS (see measurement diagrams in pictures).We offer a complete line of Drive Shafts. If this is not the Drive Shaft you are looking for, there is no problem with us making a unit to your specifications at a fraction of the cost you would pay elsewhere.
We are a full service Drive Shaft Shop. Or Canada, including all U.No product will be accepted for return that has been installed, attempted to be installed or used. Trans Axles & Driveshaft Distributors TADD A division of A-1 Drive Shaft Co. We are a full service Driveline shop that has been in Business for over 30 years and can take care of almost any Driveshaft issue. The item "CUSTOM BUILT CONV DRIVE SHAFT 7290 OR 7260 SERIES FOR DODGE, CHRYSLER & PLYMOUTH" is in sale since Monday, December 5, 2016.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Transmission & Drivetrain\Universal Joints & Driveshafts". The seller is "taddcom" and is located in Milwaukee, Wisconsin.This item can be shipped to United States, Canada.